Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
- 14. Brake system
   14.1. Specifications
   14.2. Pumping of hydraulic system of a drive of brakes
   14.3. Check of brake tubes and hoses
   14.4. Replacement of brake hoses
   14.5. Height of installation of a pedal of a brake
   14.6. Free wheeling of a pedal of a brake
   14.7. Distance of a pedal of a brake from a floor
   14.8. Check of the vacuum amplifier of brakes
   14.9. Parking brake
   14.10. Brake pedal
   14.11. Main brake cylinder
   14.12. Vacuum amplifier of brakes
   14.13. Replacement of forward brake shoes
   14.14. Replacement of brake shoes on back drum-type brakes
   14.15. Replacement of brake shoes on back disk brakes
   14.16. Parking brake
   14.17. Block of hydraulic management (HCU)
   14.18. Forward sensor of frequency of rotation of a wheel
   14.19. Back sensor of frequency of rotation of a wheel
   14.20. Gear rotor of the sensor of frequency of rotation of a wheel
   14.21. Repair of the working brake cylinder
   14.22. Main survey
   14.23. Check of functionality
   14.24. List of codes of malfunctions of brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment


a7a4cf13

14.11. Main brake cylinder

GENERAL INFORMATION

Main brake cylinder and vacuum amplifier of brakes

1–socket of the sensor of level of brake liquid;
2–tubes of brake system;
3–main brake cylinder;
4–vacuum hose;
5–a pin with a head and an opening under шплинт and a spring pin;
6–nut;
7–vacuum amplifier of brakes;
8–laying to (replace);
9–unilateral vacuum valve

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Disconnect the socket of the sensor of level of brake liquid.
3. Disconnect two brake tubes from the main brake cylinder and close them plastic jams, for an exception of hit of dirt in them.

Prevention

Brake liquid dissolves paint, plastic and isolation of wires therefore at casual hit of liquid on a paint and varnish covering of the car or its components, wash out them a large amount of water.


4. If necessary, remove the plug of a pedal of a brake, a stopper and an overlay of a pedal of a brake.
5. Remove the main brake cylinder.

Installation

PERFORMANCE ORDER
1. At installation of the new main brake cylinder adjust the provision of a pusher of the vacuum amplifier of brakes.
2. Establish the main brake cylinder on the vacuum amplifier of brakes and screw two nuts.
3. Tighten two nuts of fastening of the main brake cylinder.

Inhaling moment: 9,8–16 N • m
4. Connect two tubes of brake system.
5. Tighten nuts of fastening of tubes of brake system.

Inhaling moment: 13–22 N • m
6. Connect the socket of the sensor of level of brake liquid.
7. Remove air from a hydraulic contour of brake system.
8. Connect a wire to the negative plug of the storage battery.