Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation

KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
- 16. Body
   16.1. Specifications
   16.2. Front bumper
   16.3. Rear bumper
   16.4. Forward door
   16.5. Vlagozashchitnoye door consolidation
   16.6. Hinges of a door and shock plate of the lock of a door
   16.7. Door lock
   16.8. Internal handle of opening of a door
   16.9. External handle of a door
   16.10. Cylinder of the lock of a door
   16.11. Switches of window regulators
   16.12. A window regulator with an electric drive
   16.13. Door glass
   16.14. Back door
   16.15. Headlight
   16.16. Top stoplight
   16.17. The back combined lamp
   16.18. Ceiling
   16.19. Cowl
   16.20. Sound signal
   16.21. Combination of devices
   16.22. Repair of a combination of devices
   16.23. Replacement of filament lamps of a combination of devices
   16.24. Printed-circuit board
   16.25. Top decorative overlay of the dashboard
   16.26. Switches
   16.27. Central panel
   16.28. Overlay of the central console
   16.29. Central console
   16.30. Regulator of illumination of the dashboard
   16.31. Left and right lattices of a heater of a windscreen
   16.32. Left and right lateral lattices of a heater
   16.33. Air lines of system of heating and ventilation
   16.34. Floor air lines
   16.35. Ware box
   16.36. Cable of opening of the lock of a cowl
   16.37. Handle of opening of the lock of a cowl
   16.38. Dashboard
   16.39. Control panel heating and ventilation
   16.40. External rear-view mirror
   16.41. Replacement of glass of an external rear-view mirror
   16.42. Forward seats
   16.43. Upholstery of a back of a forward seat
   16.44. Upholstery of a pillow of a forward seat
   16.45. The leaning-back hinge of a forward seat
   16.46. Back sitting
   16.47. Seat belts
   16.48. Clamp of a forward seat
   16.49. Forward humeral seat belt
   16.50. Seat belts of a back seat
   16.51. Bracket of fastening of a back seat belt
   16.52. Humeral back seat belt
   16.53. Top furnish of a forward rack
   16.54. Bottom furnish of the central rack
   16.55. Top furnish of the central rack
   16.56. Furnish of a back rack
   16.57. Support furnish for a foot
   16.58. Upholstery of a forward door
   16.59. Upholstery of a back door
   16.60. Trunk lid
   16.61. Trunk lid hinge
   16.62. Hoses of a washer of a windscreen
   16.63. Engine of a washer of a windscreen
   16.64. Screen wiper lever
   16.65. Sprays
   16.66. Replacement of brushes of a screen wiper
   16.67. Drafts of a screen wiper
   16.68. Screen wiper engine
   16.69. Distances between body points
+ 17. Central air
+ 18. Electric equipment

16.19. Cowl

GENERAL INFORMATION

Cowl

1–vlagozashchitny strip;
2–rubber emphasis;
3–cowl hinge;
4–cowl;
5–cowl support;

6–holder of a support of a cowl;
7–cable of opening of the lock of a cowl;
8–cowl lock (latch);
9–hose of a washer of a windscreen

Removal

PERFORMANCE ORDER

1. Open a cowl and fix it on a support.
2. Support a cowl so that it did not fall after a reversing of bolts of fastening of hinges.
Attention Removal of a cowl carry out with assistants.
	3. Turn out four bolts of fastening of hinges of a cowl.
4. Separate a cowl support from a cowl.
5. Remove a cowl.

Installation

Attention

Installation of a cowl carry out with assistants.

PERFORMANCE ORDER

1. Installation is carried out to sequences, return to removal.
2. Tighten bolts of fastening of a cowl by hand.
3. Close a cowl.
	4. Check gaps on cowl perimeter. If necessary, moving a cowl in the extended openings for bolts of fastening of a cowl, adjust the provision of a cowl so that gaps on perimeter were uniform and corresponded to demanded values. After situation adjustment, tighten bolts of fastening of a cowl. Inhaling moment: 18–26 N • m
	5. Check alignment of the lock mechanism and a shock plate of a cowl. If necessary, weaken bolts and, moving, adjust the provision of a shock plate of a cowl. Inhaling moment: 8–11 N • m