Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation

KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
- 8. Coupling
   8.1. Specifications
   8.2. Pumping of hydraulic system of a drive of coupling
   8.3. Adjustment of a pedal of coupling
   8.4. Coupling pedal
   8.5. Main cylinder of coupling
   8.6. Working cylinder of coupling
   8.7. Coupling disk
   8.8. Check of the bearing of switching off of coupling
   8.9. Check of a casing of coupling with a press disk
   8.10. Check of a disk of coupling
   8.11. Check of the central bearing
   8.12. Flywheel check
   8.13. Repair of the main cylinder of coupling
   8.14. Repair of the working cylinder of coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment

8.6. Working cylinder of coupling

GENERAL INFORMATION

Prevention

As the liquid used in a hydraulic drive, dissolves paint, substitute for collecting liquid the suitable container.

At liquid hit on a paint and varnish covering of the car wash out it a large amount of water.

After a detachment of a hydraulic tube of coupling, close a tube to avoid losses of brake liquid.

Working cylinder of coupling

1–hydraulic tube;
2–bolt;

3–working cylinder of coupling

Removal

PERFORMANCE ORDER

1. Lift the car and fix on support.
2. Turn out seven screws and remove an antisplash guard of a motor compartment.
	3. The special OK130430019 tool disconnect a hydraulic tube from the working cylinder of coupling.
4. Turn out two bolts of fastening of the working cylinder of coupling and remove it.

Installation

PERFORMANCE ORDER

1. Establish the working cylinder of coupling.

2. Screw two bolts of fastening of the working cylinder of coupling.

Inhaling moment: 18,6–25,5 N • m

3. The special OK130430019 tool connect a hydraulic tube to the working cylinder of coupling.

Inhaling moment: 12,7–21,5 N • m

4. Remove air from a hydraulic contour of coupling.

5. Check absence of leakages of brake liquid from a hydraulic contour of coupling.

6. Carry out road tests of the car.