Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation

KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
- 8. Coupling
   8.1. Specifications
   8.2. Pumping of hydraulic system of a drive of coupling
   8.3. Adjustment of a pedal of coupling
   8.4. Coupling pedal
   8.5. Main cylinder of coupling
   8.6. Working cylinder of coupling
   8.7. Coupling disk
   8.8. Check of the bearing of switching off of coupling
   8.9. Check of a casing of coupling with a press disk
   8.10. Check of a disk of coupling
   8.11. Check of the central bearing
   8.12. Flywheel check
   8.13. Repair of the main cylinder of coupling
   8.14. Repair of the working cylinder of coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment

8.12. Flywheel check

PERFORMANCE ORDER

	1. Check a condition of a surface of a friction of a flywheel on lack of cracks, пригара and wear of a surface. It is necessary to remove traces of insignificant development or a podgoraniye with an emery paper.
2. Check a condition of teeths of a gear wreath of a flywheel on lack of wear and a vykrashivaniye. If necessary, replace a gear wreath of a flywheel.

Installation

PERFORMANCE ORDER

	1. A hammer and a tubular opravka establish the central bearing. External diameter of the bearing of 35 mm.
2. Clear a carving of bolts of fastening of a flywheel of the hermetic remains. Before a vvorachivaniye of bolts, put on a carving of bolts fresh hermetic.
3. Establish a flywheel and the special adaptation ОК590 111 004, block it from a provorachivaniye.
	4. In a certain sequence tighten bolts of fastening of a flywheel. Inhaling moment: 96,1–103,0 N • m
5. Clear shlitsa in a nave of a disk of coupling and put on them a thin layer of greasing on the basis of a molybdenum disulfide.
	6. Establish a disk of coupling and center it a special opravka ОК130 160 010.
7. Establish a casing of coupling with a press disk on directing pins of a flywheel.
	8. Gradually, in diagonal sequence and in a certain order tighten bolts of fastening of a flywheel. Inhaling moment: 17,6–26,5 N • m
9. Establish a transmission.