Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation


KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
- 5. Power supply system and release
   5.1. Adjustment of a cable of an accelerator
   5.2. Check of a filtering element of the air filter
   5.3. Elements of system of production of the fulfilled gases
   5.4. A filtering element of the air filter
   5.5. Check of a corner of an advancing of ignition and frequency of rotation of idling
   5.6. Electronic control unit engine (ESM)
   5.7. Check of system of ventilation of a case (PCV)
   5.8. Check of system of catching паров fuels
   5.9. Check of the valve of system of catching паров fuels
   5.10. Separator check паров fuels
   5.11. Check of the bilateral valve of control
   5.12. Canister check with absorbent carbon
   5.13. Valve check паров fuels
   5.14. Sensor of measurement of a consumption of air (TED)
   5.15. Vacuum check
   5.16. Sensor of measurement of a consumption of air (TED)
   5.17. The sensor of temperature of cooling liquid
   5.18. Sensor of provision of a butterfly valve
   5.19. The warmed sensor of oxygen
   5.20. Check of forward and back warmed sensors of oxygen
   5.21. Main relay
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment

a7a4cf13

5.18. Sensor of provision of a butterfly valve

Resistance check

PERFORMANCE ORDER
1. Disconnect the socket from the sensor of provision of a butterfly valve.
2. Connect an ohmmeter between contacts 2 and 3 sockets.
3. Check that resistance of the sensor increases in proportion to a butterfly valve angle of rotation.

Resistance: 2±0,4 kiloohm at the closed butterfly valve
4. If resistance of the sensor differs from demanded values, replace it.
5. Connect to the sensor the socket.

Tension check

PERFORMANCE ORDER
1. Check that the butterfly valve is completely closed.
2. Include ignition.
3. Connect the voltmeter to contacts 3 (BLU/ORG wire) and 1 (BLK/GRN wire) the socket of the sensor of provision of a butterfly valve.
4. Check that the butterfly valve is completely closed.
5. Completely open a butterfly valve and check tension on contact 3 sockets.
Tension at completely closed butterfly valve: 0,4-0,6B
Tension at completely open butterfly valve: 4,1-4,3B
6. Otherwise replace the sensor of provision of a butterfly valve.
Prevention

The sensor of provision of a butterfly valve is not regulated and not replaced, as it is an integral part of throttle knot.