Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation

KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
- 17. Central air
   17.1. Specifications
   17.2. Check of the relay of the compressor of the conditioner
   17.3. Check of the switch of the conditioner
   17.4. Check of thermocontact of the conditioner
   17.5. Fan / evaporator
   17.6. Check of the engine of the fan
   17.7. Check of the block of resistors of the engine of the fan
   17.8. Conditioner compressor
   17.9. Check of the switch of the fan
   17.10. Belt of a drive of the compressor of the conditioner
   17.11. Kondensor
   17.12. Kondensor fan
   17.13. Check of the relay of the fan of a kondensor
   17.14. Heater block
   17.15. Control unit heating and ventilation
+ 18. Electric equipment

17.8. Conditioner compressor

Removal

PERFORMANCE ORDER

1. Discharge air central air.
2. Remove the bottom casing of the compressor of the conditioner.
	3. Remove the conditioner compressor, as is shown in drawing. Immediately close all open openings and tubes for an exception of hit of moisture of air in air central air.

Installation

PERFORMANCE ORDER

1. Installation of the compressor of the conditioner is carried out to sequences, return to removal, taking into account the following:
   – fill in in the compressor fresh oil;
   – before installation of sealing rings, oil them;
   – do not grease connecting nuts of unions of the compressor of the conditioner;
   – tighten entrance and target hoses the moment of an inhaling of 24-31 N • m;
   – adjust a tension of a belt of a drive of the compressor of the conditioner.

2. Establish the bottom casing of the compressor of the conditioner.

3. Fill with a coolant air central air.