Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Mechanical transmission
   9.1. Specifications
   9.2. Check of level of BF DOHC oil
   9.3. Check of level of TE DOHC oil
   9.4. Oil replacement
   9.5. Replacement of an oil sealing ring
   9.6. Removal and transmission installation
   9.7. Dismantling, check and assembly of a fifth / reverse gear and back cover of BF DOHC
   9.8. Dismantling, check and assembly of a fifth / reverse gear and back cover of TE DOHC
   9.9. Case of coupling and components of a case of a transmission of BF DOHC
   9.10. Case of coupling and components of a case of a transmission of TE DOHC
   9.11. Primary shaft of a transmission of BF DOHC
   9.12. Primary shaft of a transmission of TE DOHC
   9.13. Secondary shaft of a transmission of BF DOHC
   9.14. Secondary shaft of a transmission of TE DOHC
   9.15. Choice of adjusting laying
   9.16. Differential
   9.17. Gear shifting mechanism
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment


a7a4cf13

9.5. Replacement of an oil sealing ring

PERFORMANCE ORDER
1. Lift the car and fix on support.
2. Turn out a stopper the oil plum, located in an end face of a transmission and merge oil in the suitable container.
3. Remove a forward wheel.
4. Remove a mudguard.
5. Disconnect the forward stabilizer of cross-section stability from the bottom lever.

Prevention

Do not damage dustproof covers.


6. Turn out a coupling bolt, mount wring out the bottom lever down, and separate a hinge pin from a rotary fist.
7. Turn out a nut and a stripper of OK130283021 squeeze out a pin of the hinge of a tip of steering draft from a rotary fist.

Prevention

Do not damage the hinge of equal angular speeds (CV JOINT) at separation of a power shaft from a transmission.


8. Insert mount between the internal CV JOINT of a power shaft and a transmission and easy blow on mount, take a power shaft from a transmission.

9. For an exception of damage of the external CV JOINT of a power shaft, a cord tie up a power shaft.

10. An edge of a flat screw-driver, remove a sealing ring from a transmission nest.

Prevention

Clear a nest of a sealing ring and put on it a thin butter layer. Oil a working edge of a new sealing ring.



11. Using an opravka of OK201 170 AA1, establish a new sealing ring in a nest of a case of a transmission.

12. Replace a lock ring on the internal end of a power shaft and insert a power shaft into a transmission, thus a cut of a lock ring should settle down from above.