Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation

KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
- 8. Coupling
   8.1. Specifications
   8.2. Pumping of hydraulic system of a drive of coupling
   8.3. Adjustment of a pedal of coupling
   8.4. Coupling pedal
   8.5. Main cylinder of coupling
   8.6. Working cylinder of coupling
   8.7. Coupling disk
   8.8. Check of the bearing of switching off of coupling
   8.9. Check of a casing of coupling with a press disk
   8.10. Check of a disk of coupling
   8.11. Check of the central bearing
   8.12. Flywheel check
   8.13. Repair of the main cylinder of coupling
   8.14. Repair of the working cylinder of coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment

8.2. Pumping of hydraulic system of a drive of coupling

GENERAL INFORMATION

Any hydraulic system works normally if air is removed from it.

Prevention

Liquid in an additional tank of brake system should be supported at level 3/4 or is higher in the course of pumping.

During removal of air add only pure liquid recommended by the manufacturer. The liquid used in a hydraulic drive, dissolves paint and plastic therefore at liquid hit on a paint and varnish covering of the car wash out it a large amount of water.

PERFORMANCE ORDER

1. Lift the car and fix on support.
2. Turn out seven screws and remove an antisplash guard of a motor compartment.
3. Unscrew a cover from the union of pumping and attach to it a hose.
	4. Arrange other end of a hose in glass capacity, sufficient volume.
5. Slowly press a coupling pedal several times.
6. At the pressed pedal of coupling weaken the union of pumping and let the air out from hydraulic system.
7. Tighten the union of pumping and release a coupling pedal.
8. Repeat operations 5-6 until there will be a brake liquid without air vials.
9. Check correctness of work of coupling.
10. Screw a cover on the pumping union.
11. Establish an antisplash guard of a motor compartment and fix his family screws.
12. Lower the car.