Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
- 7. Ignition system
   7.1. Specifications
   7.2. Ignition coil
   7.3. Spark plugs
   7.4. High-voltage wires
   7.5. Corner of an advancing of ignition
   7.6. Sensor of provision of a camshaft
   7.7. Sensor of an angle of rotation of a cranked shaft
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment


a7a4cf13


7.2. Ignition coil

Tension check

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Disconnect the socket from the ignition coil.
3. Turn a key in the ignition lock in the situation "ON".
4. Measure tension between dark blue and green wires in the socket of the coil of ignition.

Tension: 12 In

5. In the absence of tension, check serviceability of a safety lock, the lock of ignition and a plait of wires.

Resistance check

PERFORMANCE ORDER
1. An ohmmeter check resistance of primary winding of the coil of ignition. Connect one щуп an ohmmeter to positive (+) to a clip and another щуп to each negative (–) to a clip. If resistance differs from demanded, replace the ignition coil. Remember that the block contains two coils which resistance is necessary for checking.

Resistance of primary winding: 0.45–0.55 Ohm at 20°C

2. An ohmmeter check resistance of a secondary winding of the coil of ignition. If resistance differs from demanded, replace the ignition coil.

Resistance of a secondary winding: 13–15 kiloohms at 20°C

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Disconnect high-voltage wires.
3. Disconnect sockets from the ignition coil.
4. Turn out four bolts of fastening of the coil of ignition.
5. Remove ignition coils.

Installation

PERFORMANCE ORDER
1. Establish two coils of ignition over spark plugs of 2 and 4 cylinders and press them for connection.
2. Screw four bolts of fastening of the coil of ignition.

Inhaling moment: 19–25 N • m

3. Connect sockets to the ignition coil.
4. Connect high-voltage wires.
5. Connect a wire to the negative plug of the storage battery.