Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation


KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
- 5. Power supply system and release
   5.1. Adjustment of a cable of an accelerator
   5.2. Check of a filtering element of the air filter
   5.3. Elements of system of production of the fulfilled gases
   5.4. A filtering element of the air filter
   5.5. Check of a corner of an advancing of ignition and frequency of rotation of idling
   5.6. Electronic control unit engine (ESM)
   5.7. Check of system of ventilation of a case (PCV)
   5.8. Check of system of catching паров fuels
   5.9. Check of the valve of system of catching паров fuels
   5.10. Separator check паров fuels
   5.11. Check of the bilateral valve of control
   5.12. Canister check with absorbent carbon
   5.13. Valve check паров fuels
   5.14. Sensor of measurement of a consumption of air (TED)
   5.15. Vacuum check
   5.16. Sensor of measurement of a consumption of air (TED)
   5.17. The sensor of temperature of cooling liquid
   5.18. Sensor of provision of a butterfly valve
   5.19. The warmed sensor of oxygen
   5.20. Check of forward and back warmed sensors of oxygen
   5.21. Main relay
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment

a7a4cf13

5.16. Sensor of measurement of a consumption of air (TED)

Removal

Prevention

Do not throw and do not strike the sensor as it will lead to its damage.

PERFORMANCE ORDER
1. Disconnect the socket from the sensor of a consumption of air.
2. Weaken collars of fastening of an inlet air branch pipe from two parties of the sensor of a consumption of air.
3. Disconnect an inlet air branch pipe from the sensor of a consumption of air.
4. Turn out two bolts of fastening of the sensor of a consumption of air to an arm.
5. Remove the sensor of a consumption of air.

Check

PERFORMANCE ORDER
Visually check the sensor of a consumption of air on absence of damages. If necessary, replace it.

Installation

PERFORMANCE ORDER
1. Put the sensor of a consumption of air to an inlet air branch pipe and an arm.
2. Screw two bolts of fastening of the sensor to an arm.

Inhaling moment: 7,8–10,8 N • m
3. Connect to the sensor an inlet air branch pipe.
4. Tighten collars from two parties of the sensor.
5. Connect the socket to the sensor of a consumption of air.
6. Start up the engine and warm up it to normal working temperature. Leave the engine to work at frequency of rotation of idling.
7. Connect the voltmeter between contact 4 (RED/WHT a wire) and weight.
8. Be convinced that tension changes within 0,8–1,2 Century.
9. Switch off the engine and be convinced that tension is in limits of 3,5-4,0 Century.