Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
- 3. Greasing system
   3.1. Specifications
   3.2. Check of level of engine oil
   3.3. Replacement of engine oil
   3.4. Replacement of the oil filter
   3.5. Check of pressure of oil
   3.6. Oil pallet
   3.7. Oil pump
   3.8. Repair of the oil pump
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment


a7a4cf13

3.7. Oil pump

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Turn out a stopper plum of oil and merge oil from the engine.
3. Remove a gear belt of a drive of the gas-distributing mechanism.
4. Remove the oil pallet and a maslozaborny tube with the mesh filter.
5. Remove the generator.
6. Remove the compressor of the conditioner and an arm of the compressor of the conditioner.
7. Turn out a bolt of fastening of a pulley of a gear belt of a cranked shaft.
8. Remove a pulley of a gear belt from a cranked shaft.
9. Turn out bolts of fastening of the oil pump.

10. Remove the oil pump from the block of cylinders of the engine.

Installation

PERFORMANCE ORDER
1. Put a continuous layer of hermetic on an interfaced surface of the oil pump. After drawing of hermetic it is necessary to establish the pallet no more than in 5 minutes.
2. Grease with engine oil a working edge of a new sealing ring and establish it in the case of the oil pump.

3. Establish the oil pump and fix bolts.

Inhaling moments: 19–26 N • m

4. Establish a pulley of a gear belt on a cranked shaft and fix a bolt.

Inhaling moments: 156,8–166,6 N • m

5. Establish an arm of the compressor of the conditioner and the compressor of the conditioner and fix bolts.
6. Establish the generator.
7. Establish a maslozaborny tube with the mesh filter and the oil pallet.
8. Establish a gear belt of a drive of the gas-distributing mechanism.
9. Fill in in the engine necessary amount of demanded engine oil.
;

10. Connect a wire to the negative plug of the storage battery.

11. Start up the engine and check absence of leakages of oil.
12. Check level of engine oil and, if necessary, finish it to norm.