Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
- 18. Electric equipment
   18.1. Specifications
   18.2. Electric chains
   18.3. Safety locks
   18.4. Storage battery
   18.5. Check of level and density of electrolit and charging
   18.6. Unattended batteries
   18.7. Wires and plugs
   18.8. Charging of standard batteries
   18.9. Starter
   18.10. Switch of blocking of a starter
   18.11. Removal and starter installation
   18.12. Starter repair
   18.13. Check of the traction relay
   18.14. Check of brushes and shchetkoderzhatel
   18.15. Check of coils of a stator
   18.16. Rotor check
   18.17. Generator
   18.18. Belt of a drive of the generator
   18.19. Removal and generator installation
   18.20. Generator repair
   18.21. Check of a heater of back glass
   18.22. Safety cushion of the driver
   18.23. Safety cushion of the forward passenger
   18.24. Spiral wire
   18.25. Diagnostics of malfunctions of system of start-up and methods of their elimination
   + 18.26. Electric circuits


a7a4cf13

18.24. Spiral wire

Removal
Prevention

The socket of a spiral wire is an integral part of the combined switch and is not served as a separate part.


PERFORMANCE ORDER
1. Remove a safety cushion of the driver.
2. Turn out a nut of fastening of a steering wheel. Put combination labels on a steering shaft and a steering wheel, for the correct repeated installation.
3. A stripper, remove a steering wheel.
4. Turn out three screws of fastening of a spiral wire, disconnect three sockets and remove the case of a spiral wire.

Installation

PERFORMANCE ORDER
1. Temporarily according to earlier put labels establish a steering wheel and establish forward wheels for movement directly forward.

Prevention

The centering finger is used alignments of the socket of a spiral wire at installation of a steering wheel on a steering column. The centering finger is delivered with the new combined switch and is necessary for installation of an original spiral wire. The centering finger has diameter of 3 mm and length of 76 mm.


2. Establish the block of a spiral wire and fix three screws.

Inhaling moment: 0,92 N • m
3. Turn the central part of a spiral wire clockwise against the stop. Turn the central part of a spiral wire counter-clockwise on 2 and 1/2 turns and combine arrows on the case and the central part of a spiral wire.
4. Insert a centering finger into an opening from the face of the central part of a spiral wire so that it entered into an opening from a reverse side of the case.
5. Reinstall a steering wheel, having combined the labels put before removal and having passed an adjusting finger through an oblong opening in a steering wheel. Screw a nut of fastening of a steering wheel and tighten it the demanded moment.

Inhaling moment: 39–49 N • m
6. Establish a safety cushion of the driver.