Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. Automatic transmission
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
- 18. Electric equipment
   18.1. Specifications
   18.2. Electric chains
   18.3. Safety locks
   18.4. Storage battery
   18.5. Check of level and density of electrolit and charging
   18.6. Unattended batteries
   18.7. Wires and plugs
   18.8. Charging of standard batteries
   18.9. Starter
   18.10. Switch of blocking of a starter
   18.11. Removal and starter installation
   18.12. Starter repair
   18.13. Check of the traction relay
   18.14. Check of brushes and shchetkoderzhatel
   18.15. Check of coils of a stator
   18.16. Rotor check
   18.17. Generator
   18.18. Belt of a drive of the generator
   18.19. Removal and generator installation
   18.20. Generator repair
   18.21. Check of a heater of back glass
   18.22. Safety cushion of the driver
   18.23. Safety cushion of the forward passenger
   18.24. Spiral wire
   18.25. Diagnostics of malfunctions of system of start-up and methods of their elimination
   + 18.26. Electric circuits


a7a4cf13

18.12. Starter repair

GENERAL INFORMATION

Starter

1–traction relay;
2–back cover;
3–a shchetkoderzhatel with brushes;
4–a stator with coils;

5–forward cover;
6–lever;
7–obgonny coupling;
8–rotor

Dismantling

PERFORMANCE ORDER
1. Turn out a nut from the plug M.
2. Remove a stator wire from the plug M.
3. Turn out two screws and remove the traction relay.
4. Remove a spring of a plunzher of the traction relay.
5. Disconnect a plunzher from the lever, and remove a plunzher.
6. Turn out hairpins of fastening of a back cover. Remove a forward cover from the starter engine. At existence, remove from the engine planetary transfer.
7. Remove the lever.
8. A tubular opravka bring down a clamp of a lock ring.
9. Remove a lock ring.
10. Remove a clamp of a lock ring and the obgonny coupling.
11. Turn out two screws and remove a back cover with a shchetkoderzhatel.
12. Take a rotor from a stator.
13. Remove washers from a rotor shaft.