Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation



KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
- 10. Automatic transmission
   10.1. Check of work and adjustment of position of the lever of the selector
   10.2. Check of level and liquid replacement in an automatic transmission
   10.3. Procedure of replacement of liquid in the converter of an automatic transmission
   10.4. Leakages of liquid from an automatic transmission
   10.5. Replacement of oil sealing rings
   10.6. Block of valves of management
   10.7. Radiator of cooling of liquid of an automatic transmission
   10.8. Removal and installation of an automatic transmission
   10.9. Repair of an automatic transmission
   10.10. Oil pump
   10.11. The case of the regulating valve
   10.12. O/D switch
   10.13. Switch of a range of a transmission
   10.14. Sensor of temperature of an automatic transmission
   10.15. The sensor of frequency of rotation on entrances / turbines
   10.16. Sensor of speed
   10.17. Electromagnetic valves
   10.18. Linear electromagnetic valve
   10.19. Selector lever
   10.20. Repair of the lever of the selector
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment


a7a4cf13

10.6. Block of valves of management

Check


Prevention

Before removal of the block of valves clear an external surface of a transmission a cleaner or solvent.


PERFORMANCE ORDER
1. The special AA0 adaptation OK201 170 support the engine.
2. Lift the car and fix on support.
3. Merge liquid from a transmission in the suitable container.
4. Turn out on seven screws and remove the left and right mudguards of a motor compartment.
5. Turn out two nuts of fastening of a support of No. 2 engines to the engine.
6. Turn out bolts and nuts and remove a plate of protection of the engine.
7. Turn out 19 bolts and remove the oil pallet and laying.
8. Disconnect all electric sockets, turn out eight bolts and remove the block of valves of management.

Installation

PERFORMANCE ORDER
1. Establish the block of valves of management, fix eight bolts and clips of wires.

Length of bolts:
And – 30 mm
In – 50 mm
Inhaling moment: 7,9–10,7 N • m

2. Establish the oil mesh filter and fix three bolts.

Inhaling moment: 7,9–10,7 N • m

3. Connect all electric sockets.

4. Clear interfaced surfaces of the oil pallet and a transmission case of the remains of old laying. Establish the oil pallet with new laying and fix nineteen bolts.

Inhaling moment: 8,4–10,7 N • m

5. Establish a plate of protection of the engine and, freely screw bolts and nuts.

6. Tighten nuts And and bolts In fastenings of a plate of protection of the engine.

Inhaling moment:
And – 38–51 N • m
In – 48–65 N • m

7. Establish the left and right mudguards of a motor compartment and fix everyone seven screws.
8. Remove the special AA0 adaptation OK201 170 supporting the engine.
9. Take щуп for measurement of level of liquid and fill in necessary amount of demanded liquid. Check liquid level in an automatic transmission at operation of the engine on frequency of rotation of idling.
10. Carry out a control trip and check absence of leaks in places specified above.