Kia Sephia/Shuma/Spectra

since 1995 of release

Repair and car operation

KIA of Sefia / Noise/range
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
- 10. Automatic transmission
   10.1. Check of work and adjustment of position of the lever of the selector
   10.2. Check of level and liquid replacement in an automatic transmission
   10.3. Procedure of replacement of liquid in the converter of an automatic transmission
   10.4. Leakages of liquid from an automatic transmission
   10.5. Replacement of oil sealing rings
   10.6. Block of valves of management
   10.7. Radiator of cooling of liquid of an automatic transmission
   10.8. Removal and installation of an automatic transmission
   10.9. Repair of an automatic transmission
   10.10. Oil pump
   10.11. The case of the regulating valve
   10.12. O/D switch
   10.13. Switch of a range of a transmission
   10.14. Sensor of temperature of an automatic transmission
   10.15. The sensor of frequency of rotation on entrances / turbines
   10.16. Sensor of speed
   10.17. Electromagnetic valves
   10.18. Linear electromagnetic valve
   10.19. Selector lever
   10.20. Repair of the lever of the selector
+ 11. Axes and power shafts
+ 12. Steering
+ 13. Wheels and tires
+ 14. Brake system
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment

10.17. Electromagnetic valves

Removal

PERFORMANCE ORDER

1. Disconnect a wire from the negative plug of the storage battery.
2. Disconnect the socket from the electromagnetic valve.
3. Measure resistance between each contact and "weight". Resistance: 14–18 Ohm
Prevention 2: valve of the converter of a torque; 3: electromagnetic valve A; 6: electromagnetic valve B; 9: electromagnetic valve C.
	4. Otherwise check an electric chain on break or short circuit. Replace the electromagnetic valve.

Conductivity check

PERFORMANCE ORDER

1. Disconnect the 55-contact socket from the control unit an automatic transmission.

2. Check conductivity between C221-30, C221-33, C221-32 and C221-4 plugs, and "weight".

3. If conductivity is absent, check electric chains.